WrapidSeal™ is easy to install and requires minimal surface preparation:

  • Take a wire brush around the area of the structure that will be covered;

  • Take your blow torch to the structure to remove the loose dirt and any moisture within the structure;

  • Measure the largest diameter of the structure and cut your piece of WS adding 6-8” for an overlap;

  • Using a roller, paint the primer on the entire section of the structure that will be covered;

  • Loosely wrap the sleeve around the structure making sure there is an overlap;

  • Heat the closure seal and place on top of overlap using roller to lay it down;

  • Begin heating the sleeve, starting at the bottom and working your way up until the sleeve has shrunk to tightly encapsulate the structure.

Back to About WrapidSeal™